NEC Xen IPK - Delay Announcement Interval; Automated Attendant 1 St to 2 Nd Delay Announcement Interval Time Selection

186 – Chapter 1 DRAFT 3 Automated Attendant 1
st
to 2
nd
Delay Announcement Interval Time Selection, 1-4-19
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-4-19
System Mode
1
Submode
4
Data No.
19
PC Programming
+ AU
Automated Attendant 1
st
to 2
nd
Delay Announcement Interval
Time Selection
General Description
Use this Memory Block to specify the interval time between the Automated Attendant Delay
Announcement messages.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
Immediate
(0s)
10 sec.
(10s)
20 sec.
(20s)
30 sec.
(30s)
LK 5 LK 6 LK 7
LK 8
1 min.
(1m)
2 min.
(2m)
3 min.
(3m)
4 min.
(4m)
LK9 LK10 LK11 LK12
5 min.
(5m)
10 min.
(10m)
20 min.
(20m)
Programming Procedures
1
Go off-line.
2
Press LK1 + LK4 + AIto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Example: To change 4 minutes to 10 seconds, press CO/PBX line key 2.
Default Values
4 min.
4
Press N to write the selected data and advance to Memory Block , 1-4-20 , Automated Attendant Delay Announcement
Disconnect Time Selection.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-4-18 Automated Attendant Delay Announcement Assignment
1-4-20 Automated Attendant Delay Announcement Disconnect Time Selection
1 9 : 1 s t I N T R V L 4 m
T I M E D I S P L A Y
Data
No.
Title
Setting
Data