NEC Xen IPK - Automated Attendant Message Access Code (1-Digit Assignment

1-4-14, Automated Attendant Message Access Code (1-Digit) Assignment DRAFT 3 Chapter 1 – 179
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-4-14
System Mode
1
Submode
4
Data No.
14
PC Programming
+ AU
Automated Attendant Message
Access Code (1-Digit)
Assignment
General Description
Use this Memory Block to enter a 1-digit code to route an incoming call from the Automated
Attendant.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK4 + ADto access the Memory Block.
3
Use the dial pad to enter data.
Note: Use the following to enter data:
A~H to enter Automated Attendant message number
K~I to enter dial number
Setting Data Allowed
Function Code001~053 sec.
Note: 000 is unused.
Default Values
4
PressNto write the data and advance to the next dial number then to each Automated Attendant number.
5
After all data is entered, pressNto write the data.
6
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2, Guide to Feature Programming.
1 4 : A A A C 1 = 0 = 0 3 0
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
A.A. Msg.
No.
1~8
Dial No.
0~9
Dial
Number
Function
Code
Contents
9 030
Specified
Station Call (0)
1 010
Station Number
2 010
Station Number
3 010
Station Number
0,4 ~ 8 000
Unregistered