NEC Xen IPK - Printer Connected Selection

192 – Chapter 1 DRAFT 3 Printer Connected Selection, 1-5-13
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-5-13
System Mode
1
Submode
5
Data No.
13
PC Programming
+ AS
Printer Connected Selection
General Description
Use this Memory Block to program when a printer or PC is connected for SMDR use. If
the printer is disconnected from the system, an alarm sounds at stations connected to Ports
01 and 02.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
No PC Printer
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK5 +ACto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-5-02 SMDR Print Format
1-5-14 Printer Line Feed Control Selection
1-5-23 Outgoing Mode Selection
1-5-25 SMDR Valid Call Timer Assignment
1-8-35 COM Port Baud Rate Setting Assignment
1-8-36 COM Port Parity/Stop Bit Setting Assignment
N
1. Station Message Detail Recording (SMDR) cannot be used if this Memory Block is programmed for No.
2. When PC is assigned, the SMDR output data can be saved in a Comma-Separated Values (CSV) format file on a PC.
The file can then be opened using PC software (i.e., MS Excel) to analyze, filter, and/or sort the data.
1 3 : P R I N T E R N O
T I M E D I S P L A Y
Data
No. Title
Setting
Data