NEC Xen IPK - PBX;CTX Access Code Assignment I

60 – Chapter 1 DRAFT 3 PBX/CTX Access Code Assignment I, 1-1-24
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-1-24
System Mode
1
Submode
1
Data No.
24
PC Programming
+ BA
PBX/CTX Access Code
Assignment I
General Description
Use this Memory Block to specify a PBX line PBX/CTX Access Code together with pauses for
outgoing calls.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + BD to access the Memory Block.
3
Enter the data using the dial pad.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
Q to insert a pause
U to clear all data
Default Values
0-
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-92 Trunk Type Selection
N
1. Features such as Code Restriction do not operate properly unless a PBX/CTX Access Code is specified. This
limitation applies to PBX lines assigned in Memory Block 3-92 Trunk Type Selection.
2. A pause is not inserted in the number of an outgoing call on a CO line.
3. Up to three numeric characters and three pauses can be specified.
4. A pause cannot be inserted as the first digit or as consecutive digits.
5. A -(dash) is the entry for pause.
2 4 : P B X A C 0
T I M E D I S P L A Y
Data
No. Title
Setting
Data
Example:

Xen
Xen IPK System
Intercom Line
XEN IPK
PBX Line
PBX
CO Line