NEC Xen IPK - Page 407

Xen IPK Programming Manual
3-53, Caller Name Indication Selection DRAFT 3 Chapter 1 – 387
Doc. No.: 8194 - Release 2.0 December 2004
N
1. LK3 is used for System Speed Dial Name Match.
2. LK3 option will check all System Speed Dial Buffer Names assigned to Speed Dial Buffer Numbers 00~79 however, if
System is set to 1000 Speed Dial Mode, LK3 will only check 000~099 (the first 100 Buffer Numbers and Names) and
the remainder (100~999) will not be checked.
 Calls received from a Mobile Phone on an analogue COI trunk will display “MOBILE” in place of CID Name
when Memory Block 3-71 is set to CO.
 Calls received from a Pay Phone on an analogue COI trunk will display “PAYPHONE” in place of the
CID Name.
 If Memory Block 8-71 is set to “SPD” and Memory Block 3-53 is set to “Name”, the received Caller ID will
always be matched against system speed dials.
Memory Block Settings
3-53 Number Number Number Number Name Name Name Name
1-8-08 Page 4, LK3 ON ON ON ON ON ON ON ON
1-8-08 Page 4, LK4 ON ON OFF OFF ON ON OFF OFF
1-8-08 Page 5, LK7 ON OFF ON OFF OFF ON ON OFF
MLT LCD Line 1
CID
Number
CID
Number
CID
Number
CID
Number
CID
Number
CID
Number
CID
Name
CID
Name
MLT LCD Line 2
Date/
Time
Date/
Time
Date/
Time
Date/
Time
Date/
Time
CID
Name
CID
Number
Date/
Time