December 2004 NEC Business Solutions Ltd
336 – Chapter 1 DRAFT 3 System Speed Dial Display Assignment, 2-07
Doc. No.: 8194 - Release 2.0
December 2004
Programming Procedures
1
Go off-line.
2
Press LK2 + KGto access the Memory Block.
3
Press the CO/PBX Line key. The LED indication changes to indicate the data each
time the CO/PBX line key is pressed.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter number data
S to go to next page
T to go to previous page
Default Values
All Speed Dial confirmation allowed.
4
After entering data for all pages, press Nto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-35 Speed Dial Buffer Allocation
1-8-07 Class of Service (Attendant) Feature Selection 1
N
1. If Deny is specified, no display is presented even when a System Speed Dial call is originated.
2. Divide the Speed Dial numbers into groups and specify, per tenant, whether confirmation is allowed or denied.
3. Station Message Detail Recording (SMDR) prints telephone numbers.
CO/PBX
Line LED
Off On
Data
No
(Not
Assigned)
Yes
(Assigned)
There is no
default setting.
To Next Page
Loading...
