Xen IPK Programming Manual
1-15-08, Link Reconnect Allow/Deny Selection DRAFT 3 Chapter 1 – 307
Doc. No.: 8194 - Release 2.0
December 2004
1-15-11 Centralised Billing Allow/Deny Selection
1-15-12 Centralised Billing – Point Code of Center Office Assignment
1-15-13 Centralised Day/Night Switching for Remote Office Assignment
1-15-14 Centralised Day/Night Switching for Main Office Assignment
1-15-15 Centralised BLF Send Point Code Assignment
1-15-16 Centralised BLF Send Extension Number Assignment
1-15-17 Centralised BLF Send Time Assignment
1-15-18 Centralised BLF Display Extension Number Assignment
3-70 CIC Number Assignment
5-05 Common Signalling Channel Route Selection
1-1-05 Start Time Selection
1-5-02 SMDR Print Format
1-5-13 Printer Connected Selection
1-5-14 Printer Line Feed Control Selection
1-5-25 SMDR Valid Call Time Assignment
1-5-26 SMDR Incoming/Outgoing Print Selection
1-8-35 COM Port Baud Rate Setting Assignment
4-56 SMDR Telephone Print Selection
N
1. When NO is selected, Link Reconnect does not take place.
2. When Local Loop Start Trunks are used, and a disconnect signal is not received from the network, the
time set in Memory Block 1-1-05 (Start Time Selection) applies for the reconnect to take place.
Related Programming (Continued)
M.B. Number Memory Block Name
To Next Page
Loading...
