Xen IPK Programming Manual
1-15-14, Centralised Day/Night Switching for Main Office Assignment DRAFT 3 Chapter 1 – 319
Doc. No.: 8194 - Release 2.0
December 2004
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-08 Link Reconnect Allow/Deny Selection
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
1-15-10 Calling Name Display Allow/Deny Selection
1-15-11 Centralised Billing Allow/Deny Selection
1-15-12 Centralised Billing – Point Code of Center Office Assignment
1-15-13 Centralised Day/Night Switching for Remote Office Assignment
1-15-15 Centralised BLF Send Point Code Assignment
1-15-16 Centralised BLF Send Extension Number Assignment
1-15-17 Centralised BLF Send Time Assignment
1-15-18 Centralised BLF Display Extension Number Assignment
3-70 CIC Number Assignment
5-05 Common Signalling Channel Route Selection
1-1-05 Start Time Selection
1-5-02 SMDR Print Format
1-5-13 Printer Connected Selection
1-5-14 Printer Line Feed Control Selection
1-5-25 SMDR Valid Call Time Assignment
1-5-26 SMDR Incoming/Outgoing Print Selection
1-8-35 COM Port Baud Rate Setting Assignment
4-56 SMDR Telephone Print Selection
N
1. Memory Block 1-15-00 (K-CCIS Main/Remote Office Selection) is used for the Centralised Day/Night Switching
feature.
2. This Memory Block is used for the Main Office only.
3. Up to 16 Remote Offices can be controlled by a Main Office.
4. The Xen IPK cannot be a Main Office for a NEAX2000/2400 PBX.
Related Programming (Continued)
M.B. Number Memory Block Name
To Next Page
Loading...
