NEC Xen IPK - Page 31

Xen IPK Programming Manual
Programming Manual DRAFT 3 Chapter 1 – 11
Doc. No.: 8194 - Release 2.0 December 2004
22 DID Digit Conversion Table
& DNIS Assignment
Not Specified Ext. No. (Up to 4 digits)
23 DID Forward Station Number for Busy
Station or Undefined Digit
NON NON, Ext. No.
24 PBX/CTX Access Code Assignment I 0– Up to six digits (three numeric, three pauses)
25 PBX/CTX Access Code Assignment II 8– Up to six digits (three numeric, three pauses)
27 Automatic Day/Night Mode Switching
Time Assignment
Not Specified Day/Night Mode Start Time (24 hours)
28 Distinctive Ringing by Telephone or CO
Selection
Tel Tel, CO
29 Private Line Assignment Not Specified CO/PBX Line Number, Tel Port Number, up to
two lines
30 Route Advance Block Assignment All Blocks 00 (Not Set) Priority of Trunk Group Number
32 Automatic Day/Night Mode by Day of
Week Selection
(Sunday ~ Saturday) =
Pattern 1
Day/Night Automatic
Switching Pattern 1, 2
33 Speed Dial Number/Name
Display Selection
Dialled Number Dialled Number, Name
34 Tie Line First Ring Pattern Selection Pattern 3 Pattern 1, Pattern 2, Pattern 3, Pattern 4,
ICM, Voice
35 Speed Dial Buffer Allocation 100 Memories 100 Memories, 1,000 Memories
37 Trunk Queuing Timeout Selection 10 sec. 10 sec., 20 sec., 30 sec., 60 sec.
46 Access Code (1-Digit) Assignment Refer to Access Code (1-Digit) Assignment on page 1-76.
47 Access Code (2-Digit) Assignment Refer to Access Code (2-Digit) Assignment on page 1-81.
48 Access Code (3-Digit) Assignment All Dial 000 (Not Used) Refer to Access Code (1-Digit) Assignment
on page 1-76.
49 Networking Trunk Group/Route Advance
Assignment
Not Specified Trunk Group 01 ~ 32 or Route Advance Block
01 ~ 16
50 CO/PBX Outgoing Digit Add Assignment Not Specified 10 digits max. (On 9, *, #)
51 CO Line Ringing Pattern Selection RIng Pattern G Pattern A ~ H, Nil
52 PBX Line Ringing Pattern Selection Ring Pattern B Pattern A ~ H, Nil
53 Tie Line Delay Ring Pattern Selection Ring Pattern C Pattern A ~ H, Nil
54 Automated Attendant Transfer
Ring Pattern
Ring Pattern C Pattern A ~ H, Nil
55 DID Line Ringing Pattern Selection Ring Pattern C Pattern A ~ H, Nil
57 CO/PBX Prepause Timer Selection 3 sec. None, 1 sec. ~ 13 sec.
59 Synchronous Ringing Selection Yes Yes, No
60 8-Digit Matching Table Assignment Refer to 8-Digit Matching Table Assignment on page 1-98.
LK 1 System Mode
LK 1 CO Line (Continued)
Data
No.
Memory Block Name Default Value Programming Values