NEC Xen IPK - Page 151

Xen IPK Programming Manual
1-2-02, Automatic Callback Release Timer Selection DRAFT 3 Chapter 1 – 131
Doc. No.: 8194 - Release 2.0 December 2004
3
Use the dial pad to enter the time required.
Note:
Jto move cursor left.
Lto move cursor right.
Setting Data (Allow): Class 1 to Class 4: 00 to 99 sec
00 = No Limit
Default values:
Class 1 to Class 4 = 30 secs
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
4-71 Time Class Assignment for Telephone Mode (R2000 and above)
Programming Procedures (Continued)