Xen IPK Programming Manual
1-4-01, Automated Attendant First Digit PBR Release Timer Selection DRAFT 3 Chapter 1 – 167
Doc. No.: 8194 - Release 2.0
December 2004
3
Use the dial pad to enter the time required.
Note:
Jto move cursor left.
Lto move cursor right.
Setting Data (Allow): 01 to 99 sec
Default values: 20 secs
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
4-71 Time Class Assignment for Telephone Mode (R2000 and above)
N
After PBR is connected, dialling must be completed in the specified time. After the first digit is dialled, interdigit timing
(default 7 sec.) controls the PBR timer. Dialling the third digit exceeds the 20 sec. default, and the PBR is disconnected.
Programming Procedures
To Next Page
Loading...
