Xen IPK Programming Manual
1-6-05, Attendant Add-On Console Key Selection DRAFT 3 Chapter 1 – 201
Doc. No.: 8194 - Release 2.0
December 2004
Related Programming
M.B. Number Memory Block Name
1-6-00 Attendant Add-On Console to Telephone Port Assignment
7-2 Telephone Type Assignment
N
1. When TEL is assigned to a line key, the red LED is used to indicate Station Status.
2. When a function (e. g., Message or Paging) that does not require a green LED is assigned to a 2-colour LED key, the
green LED does not function.
3. Telephone number setting data for telephone sets is determined by the number of installed ESI(8)-U( ) ETUs.
4. Message Waiting and Attendant Station Outgoing Lockout cannot be assigned on the same console.
5. DSS/CO keys should be programmed on line keys 1~48 only.
6. The Feature Access key with Live Record has seven features:
7. Each function can be assigned by dialling the Feature No. using the dial pad after pressing LK1 on page 3.
8. Digital Voice Mail Mailbox Number can be entered using two, three, or four digits of the Mailbox number on the dial
pad. This feature is used for Live Record addressing. The Live Record feature must be assigned to a line key on the
console also.
Related Programming
Feature No. Feature
00 Record Start
01 Record Pause/Restart
02 Record Erase
03 Record Finish
04 Record Erase/Restart
05 Pager
06 Record Confirmation
07 Live Monitoring
To Next Page
Loading...
