NEC Xen IPK - Page 244

December 2004 NEC Business Solutions Ltd
224 – Chapter 1 DRAFT 3 Class of Service (Station) Feature Selection 2, 1-8-08
Doc. No.: 8194 - Release 2.0 December 2004
.Programming Procedures
1
Go off-line.9
2
Press LK1 + LK8 + KHto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
The LED indication changes to indicate data each time CO/PBX line key is pressed.
Note: PressS to go to the next page.
Press
T to go back to the previous page.
4
PressNkey. Data for Class 01 ~ 15 is displayed successively
5
PressNto write the data for class 15.
6
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
4-17 Station to Class of Service Feature Assignment
N
1. Sixteen Classes (00~15) of feature restriction patterns allow a station user to activate particular features while
restricting others.
2. At default, all stations are in Class 00.
3. Stations are assigned to a Class of Service in Memory Block 4-17 Station to Class of Service Feature
Assignment.
4. LCR/ARS Bypass (Page 3, LK 4) applies only when the station is assigned to an LCR/ARS Class (1~4) in
Memory Block 4-40 (LCR Class Selection). LCR/ARS Bypass does not apply when using access codes to
directly access an ARS Table (functions 601~604 – ARS Tables 1~4) in Memory Blocks 1-1-46~48 [Access
Code (1/2/3-Digit) Assignment].
5. ARS Overflow (Page 6, LK 1) allows or restricts access to Trunk Group 01 when the first priority trunk group
(programmed route) is busy.
Corresponding
CO/PBX Line Key
Function Name
Default
Class 00
Default
Class 01
~ 15
Page 01
LK1
Set Call Forward - All Call, Do Not Disturb (DND),
Break Mode
Allow Deny
LK2
Trunk Queuing
Allow Deny
LK3
Automatic Callback
Allow Deny
LK4
Barge-In Originate on a CO/PBX Line
Deny Deny
LK5
Barge-In Receive
Allow Deny
LK6
Timed Alarm (Set/Cancel)
Allow Deny
CO/PBX
Line Key LED
Off On
Data Deny Allow
Refer to Table on following
page for default settings.