NEC Xen IPK - Page 33

Xen IPK Programming Manual
Programming Manual DRAFT 3 Chapter 1 – 13
Doc. No.: 8194 - Release 2.0 December 2004
86 Call Monitoring Alert Assignment
LK 1 System Mode
LK 2 ICM
Data
No.
Memory Block Name Default Value Programming Values
00 Internal Paging Timeout Selection 90 sec. 90 sec., 120 sec., No Limit
01 Intercom Call Voice/Tone Signal Selection Tone Tone, Voice
02 Automatic Callback Release Timer
Selection
30 min. 30 sec., 1 min., 2 min., 3 min., 5 min., 10 min.,
20 min., 30 min.
03 2-, 3-, or 4-Digit Station Number Selection 3-digit 2-digit, 3-digit, 4-digit
04 Call Arrival Key Block Assignment Not specified Tel Port No. Blocks
(4 Ch Assign)
08 Specified Station Access Code
Assignment
00 = 01
01 ~ 23 Not Set
Tel. Port Number
09~18 Customised Message 1~10 Assignment 09 = Don’t Disturb
10 = Meeting
11 = Business Trip
12 = Not In
13 = With Guest
14 = Out of Office
15~18 = Not Specified
Maximum of 13 characters.
(Refer to Section 7 Character Code Tables on
page 1-541 for a list of characters.)
19 Intercom Ring Pattern Selection Pattern B Tone Off
Tone On
Patterns A~H
20 Intercom Ring Tone Selection Tone A Tones A~H
21 PHS Telephone Assignment Not specified NON, PHS, Tel No., Tel No.
22 Call Forward No Answer Timer Selection 8 sec. 4 sec., 8 sec., 12 sec., 18 sec., 24 sec., 30
sec., 60 sec.
23 System Call Park Recall Time Selection 1 min. 0.5 min., 1.0 min., 1.5 min., 2.0 min., 3.0 min.,
5.0 min., 8.0 min., 10.0 min.
24 Intercom Feature Access
Code Assignment
Refer to Intercom Feature Access Code Assignment on page 1-146.
25 Internal Paging Alert Tone Selection Tone YS Tone YS
Tone No
26 Delayed Ringing Timer Assignment (ICM) 10 sec. 00~99
28 PS Out of Area Tone Selection BT BT (Busy), RBT (Ring Back)
30 PS Out of Area Timer Selection
(BSU only)
12 sec. 00~99 sec.
LK 1 System Mode
LK 1 CO Line (Continued)
Data
No.
Memory Block Name Default Value Programming Values