NEC Xen IPK - Page 353

Xen IPK Programming Manual
2-06, Line Key Selection for Tenant Mode DRAFT 3 Chapter 1 – 333
Doc. No.: 8194 - Release 2.0 December 2004
3
Press the corresponding CO/PBX line key to change the data option.
The operation data includes:
Setting Data
Note: The following are used when entering data:
J to moves the cursor left
L to moves the cursor right
K~I to enter the numeric data
R to go to the next Tenant No.
Default Values
4
Press CO/PBX LK7; TKGP is displayed.
5
Enter K E (for RT 05) using the dial pad.
6
Press N; data of CO/PBX LK 01~24 is displayed successively.
7
After entering data for CO/PBX LK24, press N to write the data.
8
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
2-05 Line Key Selection
Programming Procedures
Line Key Setting Data (1) LCD Indication Setting Data (2)
1 Not Specified NON N/A
2 CO CO 01~64
3 CFW - BNA FW BNA N/A
4 CFW - ALL FW ALL N/A
5
Call Appearance
Block (00~47)
C
Call Appearance
Key 01~24
6 Feature Access FA 01~16
7 Trunk Group TKGP 01~32
8 Route Advance ADV 01~32
9
SIE/CAR
Key
SIE
Telephone
Port No.
01~C0
10 Microphone MIC N/A
11 Headset H SET N/A
12 Scroll Key SCROLL N/A
13 DND On/Off DND N/A
14 Log On/Off LOG N/A
15 BGM On/Off BGM N/A
16 Intercom Key ICM N/A
Line
Keys
Tenant
00
Tenant
01~47
01~08 CO/PBX lines 01~08 Not assigned
09~24 Not assigned Not assigned