NEC Xen IPK - Page 41

Xen IPK Programming Manual
Programming Manual DRAFT 3 Chapter 1 – 21
Doc. No.: 8194 - Release 2.0 December 2004
05 ACR Digit Delete Assignment 00 00~10 Digits
06 ACR Digit Add Assignment Not specified Up to 10 digits using 0~9, *, #
07 ACR Max Digit Assignment
LK 1 System Mode (Continued)
LK 14 Automatic Route Selection
Data
No.
Memory Block Name Default Value Programming Values
LK 1 System Mode
LK 15 ???
Data
No.
Memory Block Name Default Value Programming Values
00 K-CCIS Main/Remote Office Selection
02 Common Signal Channel Assignment
03 Originating Point Code Assignment
04 Destination Point Code Assignment
05 Destination Point Code Transfer
Assignment
06 Originating Office Code Number
Assignment
07 K-CCIS Message Response Timeout
Assignment
08 Link Reconnect Allow/Deny Selection
09 K-CCIS Maximum Call Forwarding Hop
Assignment
10 Calling Name Display Allow/Deny
Selection
11 Centralised Billing Allow/Deny Selection
12 Centralised Billing – Point Code of Centre
Office Assignment
13 Centralised Day/Night Switching for
Remote Office Assignment
14 Centralised Day/Night Switching for Main
Office Assignment
15 Centralised BLF Send Point Code
Assignment
16 Centralised BLF Send Extension Number
Assignment
17 Centralised BLF Send Time Assignment