Xen IPK Programming Manual
4-27, ID Outgoing Restriction Selection DRAFT 3 Chapter 1 – 433
Doc. No.: 8194 - Release 2.0
December 2004
Programming Procedures
1
Go off-line.
2
Press LK4 + KA to access the Memory Block.
3
Press the CO/PBX Line key corresponding to each CO/PBX number.
The LED indication changes to indicate data each time a CO/PBX line key
is pressed.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
R to move to the next Tel No.
S to move to the next page
T to move to the previous page
Q+1, 2, 3 = A, B or C for Port Number
Tel Port Number:
01~99 = 01~99
A0~A9 = 100~109
B0~B9 = 110~119
C0 = 120
Default Values
All stations = Available for all ID
Numbers.
4
After entering all data for all pages, pressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-19 Line Selection for Automatic Outgoing Calls
1-1-46 DID Digit Length Selection
1-1-47 DID Digit Conversion Assignment
1-1-48 DID Forward Station Number for Busy Station or Undefined Digit
1-5-23 Outgoing Mode Selection
1-9-00 DISA/ID Code Assignment
1-9-02 DISA/ID Password Effect/Invalid Selection
1-9-03 ID Restriction Class Assignment (Day Mode)
4-26 DISA/ID Number Station Assignment
N
Telephone ports A0~C0 are ports 100~120.
CO/PBX
Line Key LED
Off On
Meaning
Not
Available
Available
To Next Page
Loading...
