Xen IPK Programming Manual
4-47, ISDN Directory Number Selection DRAFT 3 Chapter 1 – 453
Doc. No.: 8194 - Release 2.0
December 2004
N
BRI:
1. When this Memory Block is set to No, the station placing an outgoing call does not present the programmed number
in Memory Block 3-52 assigned for the BRI Trunks. The Network presents Restricted for the Caller ID information.
2. When this Memory Block is set to YES, the station placing an outgoing call presents the programmed number in
Memory Block 3-52 assigned for the BRI Trunks. The Network presents the programmed number as Caller ID.
PRI:
1. When this Memory Block is set to No, and ISDN-PRI is used in CO Mode in Memory Block 3-91, the programmed
number in Memory Block 3-52 is not presented as Caller ID. The Network presents Restricted for the Caller ID
information.
2. When this Memory Block is set to YES, and ISDN-PRI is used in CO Mode in Memory Block 3-91, the
programmed number in Memory Block 3-52 is presented as Caller ID. The Network presents the programmed
number as Caller ID.
3. When this Memory Block is set to No, and ISDN-PRI is used in DID Mode in Memory Block 3-91, the programmed
number in Memory Block 3-52 is not presented as Caller ID.
4. When this Memory Block is set to YES, and ISDN-PRI is used in DID Mode in Memory Block 3-91, the
programmed number in Memory Block 4-62 is presented as Caller ID. The Network presents the programmed
number as Caller ID.
To Next Page
Loading...
