NEC Xen IPK - Page 48

December 2004 NEC Business Solutions Ltd
28 – Chapter 1 DRAFT 3 Multiline Terminal Programming
Doc. No.: 8194 - Release 2.0 December 2004
LK 5 Trunk Group Mode
Data
No.
Memory Block Name Default Value Programming Values
00 Digit Add/Del for Tie Line Networking No Add and Delete = 000 Delete up to two digits
Add up to two digits
01 Tie Line Networking Tandem Connection
Assignment
All Trunk Groups = Yes On = Yes (Enabled)
Off = No (Disabled)
02 8-Digit Matching Table to Trunk Group
Assignment
Enabled On = Use (Enabled)
Off = Not Used (Disabled)
03 OCC Table to Trunk Group Assignment Use All Tables On - Use (Enabled)
Off = Not Used (Disabled)
04 LCR Class to Trunk Group Selection
05 Common Signalling Channel Route
Assignment
06 Trunk Group Outgoing Priority Selection
LK 6 Copy Mode
Data
No.
Memory Block Name Default Value Programming Values
2 Tenant Mode Copy Assignment N/A Tenant 00~47
3 CO Line Mode Copy Assignment N/A Tenant 01~64
4 Telephone Mode Copy Assignment N/A Tenant 01~120
5 Trunk Group Mode Copy Assignment N/A Tenant 01~32
LK 7 ETU Mode
Data
No.
Memory Block Name Default Value Programming Values
1 Card Interface Slot Assignment Refer to Card Interface Slot Assignment on page 1-501..
2 Telephone Type Assignment Telephone NON
Telephone
DSS Console
SLT Adapter
Digital Voice Mail
3-00 MIF (ACD) Assignment No Assignment (00) 00~02 (MIFA PKG Assigned Port No.
3-01 MIF (LCR) Assignment No Assignment (00) 00~02 (MIFM PKG Assigned Port No.
3-02 MIF (SMDR) Assignment No Assignment (00) 00~02 (MIFM PKG Assigned Port No.
3-03 MIF (UCD) Assignment No Assignment (00) 00~02 (MIFM PKG Assigned Port No.
3-04 MIF (Caller ID) Assignment No Assignment (00) 00~02 (MIFM PKG Assigned Port No.