December 2004 NEC Business Solutions Ltd
484 – Chapter 1 DRAFT 3 Tie Line Networking Tandem Connection Assignment, 5-01
Doc. No.: 8194 - Release 2.0
December 2004
Programming Procedures
1
Go off-line.
2
Press LK5 + N+ KA to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option. Operation data includes:
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
S to go to the next page
T to go to the previous page
R to go to the next Trunk Group No.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-03
Trunk-to-Trunk Group Assignment
4-09
Telephone to Tenant Assignment
N
Tandem connection of Trunk Group-to-Trunk Group must be specified separately.
CO/PBX
Line LED
Off On
Data No Yes
There is no
default setting.
To Next Page
Loading...
