NEC Xen IPK - Page 523

Xen IPK Programming Manual
7-1, Card Interface Slot Assignment DRAFT 3 Chapter 1 – 503
Doc. No.: 8194 - Release 2.0 December 2004
4
Use the Line Key to enter Setting Data.
Note: Use the following to enter data:
J to move the cursor left.
L to move the cursor right.
K~I to enter numeric data.
S to go to the next page.
T to go to the previous page.
5
PressNto write the data.
6
PressPto go back on-line.
Programming Procedures (Continued)
Page 1
Line
Key
Setting Data LCD Indication
1 ESIB(8)-U( ) ESIB8
2 ESIE(8)-U( ) ESIB16
3 MG(8)-U( ) MG
4 HUB(8)-U( ) HUB
5NON
6NON
7NON
8NON
Page 2
Line
Key
Setting Data LCD Indication
1NON DT14
2NON DT18
3 NON DTI12
4 NON DTI16
5 NON DTI20
6 NON DTI24
7NON
8NON
Page 3
Line
Key
Setting Data LCD Indication
1 PRT(1)-U( ) PRT4
2 PRT(1)-U( ) PRT8
3 PRT(1)-U( ) PRT12
4 PRT(1)-U( ) PRT16
5 PRT(1)-U( ) PRT20
6 PRT(1)-U( ) PRT24
7 PRT(1)-U( ) PRT28
8 PRT(1)-U( ) PRT32