December 2004 NEC Business Solutions Ltd
38 – Chapter 1 DRAFT 3 Start Timer Selection, 1-1-05
Doc. No.: 8194 - Release 2.0
December 2004
4
Press N to write the data and display the next Memory Block.
5
Program the next Memory Block or press P to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-5-25 SMDR Valid Call Timer Assignment
4-71 Time Class Assignment for Telephone Mode (R2000 and above)
N
This timer is used for three different features with functions described below:
Elapsed Call Timer: The time needed after dialling until the Elapsed Call Timer is started and displayed on a Multiline
Terminal.
SMDR Start Timer: The time needed after dialling until the SMDR Valid Call Timer is started. Refer to Memory Block 1-
5-25 SMDR Valid Call Timer Assignment. For outgoing calls, both timers (SMDR Start Timer and
SMDR Valid Call Timer Assignment) must elapse before a call record is generated.
Lines set as “YES” in Memory Block 3-72, as having Reversal on Answer, do not follow this Memory Block.
Programming Procedures (Continued)
To Next Page
Loading...
