Xen IPK Programming Manual
1-1-18, System Speed Dial Restriction by Tenant DRAFT 3 Chapter 1 – 51
Doc. No.: 8194 - Release 2.0
December 2004
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + AH to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the tenant number.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
S to move to the next page
T to move to the previous page
Each time a CO/PBX line key is pressed, the LED toggles between On and Off.
Default Values
All System Speed Dial buffers can
be dialled from any tenant.
4
After entering all pages for the selected Speed Dial Buffer No., pressNto write the data. The next Speed Dial Buffer
No. is displayed.
5
After entering data for all of the Speed Dial Buffer Nos., pressNto write the data for the last Speed Dial Buffer No. The
next Memory Block is displayed.
6
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-33 Speed Dial Number/Name Display Selection
1-1-35 Speed Dial Buffer Allocation
2-01 Trunk to Tenant Assignment
4-09 Telephone to Tenant Assignment
Speed Dial buffers have nine groups. These groups are listed in the table
Speed Dial
Buffer No.
Speed Dial Number
80 Codes 1000 Codes
0X 00~09 000~099
1X 10~19 100~199
6X 60~69 600~699
7X 70~79 700~799
8X N/A 800~899
∼
∼
∼
X = Any digit 0~9
CO/PBX
Line LED
Off On
Data Restricted Not restricted
To Next Page
Loading...
