Siemens SCALANCE W1750D CLI - Page 101

CLI Commands
4.4 D
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
101
Syntax
dynamic-tacacs-proxy
no…
Parameter
Description
dynamic-tacacs-proxy
Allows the Virtual Controller network to use the IP address of the
Virtual Controller when communicating with the external TACACS
servers.
NOTE:
When dynamic-tacacs-proxy is enabled on the AP, the
TACACS server cannot identify the slave AP that generates the
TACACS traffic as the source IP address is changed.
no…
Removes the configuration.
Usage Guidelines
Use this command to enable the Virtual Controller to channel all TACACS related traffic from
the slave APs to the external TACACS server.
Example
The following example enables the dynamic TACACS proxy feature:
(scalance)(config)# dynamic-tacacs-proxy
(scalance)(config)# end
(scalance)# commit apply
Command Information
AP Platform
Command Mode
All platforms
Configuration mode