Siemens SCALANCE W1750D CLI - Show Ap Debug Ble-Table

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
327
Command Information
AP Platform
Command Mode
All platforms
Privileged Exec mode
4.16.48 show ap debug ble-table
Description
This command displays beacon details for the BLE devices detected by the AP.
Syntax
show ap debug ble-table [all | assettags | generic | mac-addr <mac>]
Usage Guidelines
Use this command to view the beacon details for the BLE devices detected by the AP.
Example
The following example shows the output of the show ap debug ble-table command:
BLE Device Table
----------------
MAC HW_Type FW_Ver Flags Status Batt(%) RSSI Major# Minor# UUID Tx_Power Last Update
Uptime
--- ------- ------ ----- ------ ------- ---- ------ ------ ---- -------- ---------- -
------
Total beacons:0
Note: Battery level for LS-BT1USB devices is indicated as USB. Note: Uptime is shown
as Days hour:minute:second.
Note: Last Update is time in seconds since last heard update.
Status Flags:L:AP's local beacon; I:iBeacon; A: Aruba Beacon; H: Aruba HiPower Beacon
:U:Image Upgrade Pending
The following example shows the output of the
show ap debug ble-table assettags
command:
(scalance)
# show ap debug ble-table assettags
BLE Device Table [Asset Tags]
------------------------------
MAC HW_Type FW_Ver Flags Status Batt(%) RSSI Asset_Tag_Id Last Update Uptime