Siemens SCALANCE W1750D CLI - Vpn Monitor-Pkt-Send-Freq

CLI Commands
4.19 V
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
657
Syntax
vpn monitor-pkt-lost-cnt <count>
no...
Parameter
Description
Default
vpn monitor-pkt-lost-cnt
<count>
Defines the number of lost packets for VPN
connection test or monitoring by the AP.
2
no…
Removes the configuration.
—
Usage Guidelines
Use this command to configure a count for the lost packets, so that the APs can determine if
the VPN connection is unavailable.
Example
The following example configures a count for the lost packets:
(scalance)(config)# vpn monitor-pkt-lost-cnt <count>
(scalance)(config)# end
(scalance)# commit apply
Command Information
AP Platform
Command Mode
All platforms
Configuration mode
4.19.11 vpn monitor-pkt-send-freq
Description
This command configures the frequency at which the AP can verify if the active VPN
connection is available.
Syntax
vpn monitor-pkt-send-freq <frequency>
no...
Parameter
Description
Default
vpn monitor-pkt- send-
freq
<frequency>
Configures a frequency interval in seconds at which the
test packets are sent.
5
no…
Removes the VPN monitoring frequency configuration.
—