Siemens SCALANCE W1750D CLI - Show Vpn Tunnels

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
611
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.227 show vpn tunnels
Description
This command shows VPN tunnel information for the AP
Syntax
show vpn tunnels
Parameter
Description
Source IP
Displays the source IP address of the VPN tunnel.
Destination
Displays the destination IP address of the VPN tunnel.
End IP
Displays the end IP address of the VPN tunnel.
Default GW
Displays the default gateway address of the VPN tunnel.
Use count
Displays the use count value.
Ifindex
Displays the VPN index value
Ifname
Displays the VPN tunnel name
Flags
Displays the VPN flag type
Retry count for Register
Request
Displays the retry count for the registration request.
GRE Encap/Decap
Displays the encapsulation or decapsulation counters of GRE
tunnel.
Old Subnet Status
Displays the VLAN addition request count.
Existing Subnet Status
Displays the previous subnet status
Usage Guidelines
Use this command to view a complete table of VPN tunnel status.
Example
The following example shows the output of show vpn-tunnels command:
Tunnel Flags: M = Master AP; S = Slave AP; Primary = Primary Tunnel
B = Backup Tunnel; R = Registered; H = Heartbeat Enable
Tunnel Info for peer address 172.16.0.254