Siemens SCALANCE W1750D CLI - Show Ap Bss-Table

CLI Commands
4.16 S
SCALANCE W1750D CLI
284 Function Manual, 03/2019, C79000-G8976-C452-04
Num Clients:0
The output of this command includes the following information:
Column
Description
Name
Indicates the Name of an AP or the AP group.
bssid
Indicates Basic Service Set Identifier (BSSID) associated with the AP. The
Basic Service Set Identifier (BSSID) is usually the MAC address of the AP.
mac
Indicates the MAC address of the AP clients.
auth
Displays the status of client authentication. Indicates
y
if the AP is configured
for 802.11 authorization frame types. Otherwise, it displays an n.
assoc
Displays the status of user association. Indicates
y
if the AP is configured for
802.11 association frame types. Otherwise, it displays an n.
aid
Indicates 802.11 association ID. A client receives a unique 802.11 associa-
tion ID when it associates to an AP.
1-int
Indicates the number of beacons in the 802.11 listen interval. There are ten
beacons sent per second, so a ten-beacon listen interval indicates a listening
interval time of 1 second.
essid
Indicates the name that uniquely identifies the AP’s Extended Service Set
Identifier (ESSID).
vlan-id
Indicates the VLAN ID associated with the AP.
tunnel-id
Indicates the identification number of the AP tunnel.
assoc. time
Indicates the amount of time the client has been associated with the AP, in
the hours: minutes:seconds format.
num assoc
Indicates the number of clients associated with the AP.
flags
Displays flags for this AP if any. For information on flag abbreviations, see the
flag description at beginning of the output.
Num Clients
Indicates the number of clients associated with the AP.
Command Information
AP Platform
Command Mode
All platforms Privileged EXEC mode
4.16.22 show ap bss-table
Description
This command displays the BSS of anAP.
Syntax
show ap bss-table