Siemens SCALANCE W1750D CLI - Show Lhm

CLI Commands
4.16 S
SCALANCE W1750D CLI
528 Function Manual, 03/2019, C79000-G8976-C452-04
---- ---------- ---- ------- ----------- -------- --------------
Server1 192.0.2.5 389 5 3 admin-dn cn=admin password123
Base-DN Filter Key-Attribute In Use
----- ------ ------------- ------
dc=example, dc=com (objectclass=*) sAMAccountName No
The output of this command provides the following information:
Command/Parameter
Description
Name
Displays the name of the LDAP authentication server.
IP Address
Displays the IP address of the LDAP server.
Port
Displays the authorization port number of the LDAP server.
Timeout
Displays a timeout value for the LDAP requests from the clients.
Retry Count
Displays number of times that the clients can attempt to connect to the
server.
Admin-DN
Displays distinguished name for the administrator.
Admin Password
Displays the password for LDAP administrator.
Base-DN
Displays a distinguished name for the node which contains the entire
user database.
Filter
Shows the filter to apply when searching for a user in the LDAP data-
base.
Key-Attribute
Displays the attribute to use as a key when searching for the LDAP serv-
er. For Active Directory, the value is sAMAccountName
In Use
Indicates if the server is in use.
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.154 show lhm
Description
This command displays the periodic and on-demand WAN link health monitoring policies
(tests) that are configured on an AP; it also shows the number of times each policy has run
on an AP
Syntax
show lhm
policy