Siemens SCALANCE W1750D CLI - Ipm

CLI Commands
4.9 I
SCALANCE W1750D CLI
188 Function Manual, 03/2019, C79000-G8976-C452-04
4.9.13 ipm
Description
This command configures IPM. It also helps set IPM power reduction steps and specify their
priorities.
Syntax
ipm
disable
enable
ipm-power-reduction-step-prio
no
Parameter
Description
Default
ipm
IPM is a feature that actively measures the
power utilization of an AP and dynamically
adapts to the power resources.
Disabled
disable
Disables IPM on the AP. —
enable
Enables IPM on the AP.
—
ipm-power-reduction-step-
prio
Sets IPM power reduction steps and specifies
their priorities.
—
no
Removes the IPM configuration.
—
Usage Guidelines
Use this command to enable or disable IPM on the AP and also to set power reduction steps
and specify their priorities.
Example
The following example enables IPM:
(scalance)(config)# ipm
(scalance)(ipm)# enable
(scalance)(ipm)# end
(scalance)# commit apply
The following example alters the IPM priority list:
(scalance)(ipm)# ipm-power-reduction-step-prio ipm-step
(scalance)(ipm)# end
(scalance)# commit apply