Siemens SCALANCE W1750D CLI - Wlan Ldap-Server

CLI Commands
4.20 W
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
705
Syntax
wifi0-mode <mode>
Parameter
Description
Range
Default
<mode>
Configures the AP to function in any of the following modes:
•
Access
— In Access mode, the AP serves clients, while
also monitoring for rogue APs in the background.
•
Monitor
—In Monitor mode, the AP acts as a dedicated
monitor, scanning all channels for rogue APs and clients.
•
Spectrum Monitor
— In Spectrum Monitor mode, the AP
functions as a dedicated full-spectrum RF monitor, scan-
ning all channels to detect interference, whether from
neighboring APs or from non-WiFi devices such as mi-
crowaves and cordless phones.
NOTE:
In Monitor and Spectrum Monitor modes, the AP does
not provide access services to clients.
access, moni-
tor, spectrum-
monitor
access
Usage Guidelines
Use this command to configure a Wi-Fi interface of an AP to function in the access, monitor,
or spectrum monitor mode.
Example
The following example configures the wifi0 interface to use the access mode:
(scalance)# wifi0-mode access
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.20.12 wlan ldap-server
Description
This command configures a LDAP server for user authentication on the virtual controller.
Syntax
wlan ldap-server <server-name>
admin-dn <domain-name>