Siemens SCALANCE W1750D CLI - Show Arm-Channels

CLI Commands
4.16 S
SCALANCE W1750D CLI
402 Function Manual, 03/2019, C79000-G8976-C452-04
149+ enable
157+ enable
The output of this command provides the following information:
Parameter
Description
Minimum Transmit Power
Displays the minimum transmission power configured for the ARM
channels.
Maximum Transmit Power
Displays the maximum transmission power configured for the ARM
channels.
Band Steering Mode
Displays the band steering mode configuration parameters
client aware
Indicates the activation status of the Client aware feature.
Scanning
Indicates if scanning for available channels is enabled.
Wide Channel Bands
Indicates if 40MHz channel are enabled on 2.4 GHz or 5 GHz band.
Air Time Fairness Mode
Displays configuration details for the Airtime Fairness Mode feature.
Spectrum Load Balancing
Indicates if the Spectrum load balancing feature is enabled or disa-
bled.
SLB NB Matching Percent
Indicates the percentage for comparing client density of AP neighbors
for spectrum load balancing.
SLB Calculating Interval
Indicates the frequency at which the client density on AP is calculated
for spectrum load balancing.
Custom Channels
Displays custom channels if any.
Channel
Displays the list of channels available in the 2.4 GHz and 5 GHz
bands.
Status
Indicates if the channels in the 2.4 GHz and 5 GHz bands are ena-
bled or disabled.
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.91 show arm-channels
Description
This command displays the ARM channel details configured on an AP.
Syntax
show arm-channels