Siemens SCALANCE W1750D CLI - Url-Visibility

CLI Commands
4.18 U
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
647
4.18.7 url-visibility
Description
This command enables url visibility on the AP and extracts the full URL information of the
http and https sessions along with the session-ip and periodically logs them on the ALE
server.
Syntax
url-visibility
no…
Parameter
Description
url-visibility
Enables URL visibility on the AP.
no
Disables URL visibility.
Usage Guidelines
Use this command to determine the frequency of hits on a specific URL. To verify if the
configuration has been applied correctly, use the
show dpi debug status command.
Example
The following example enables url visibility:
(scalance)(config)# url-visibility
(scalance)(config)# end
(scalance)# commit apply
The following example shows the output of the show dpi debug status command:
Dpimgr Running :TRUE
Dpimgr Hello count :1
Dpimgr Agent :App
Dpimgr Status value :0x17d
Dpimgr Visibility Status :URL + App
Dpimgr Enforcement Status :App
Dpimgr External Visibility Status :AMP
Command Information
AP Platform
Command Mode
All platforms
Configuration mode.