Siemens SCALANCE W1750D CLI - Ap1 X

CLI Commands
4.1 A
SCALANCE W1750D CLI
46 Function Manual, 03/2019, C79000-G8976-C452-04
Syntax
ams-key <key>
no…
Parameter
Description
<key>
Authorizes the first Virtual Controller to communicate with the AirWave server.
no…
Removes the specified configuration parameter.
Usage Guidelines
Use this command to assign a shared key for service authorization. This shared key is used
for configuring the first AP in the AP network.
Example
The following command configures the shared key for the AirWave management server.
(scalance)(config)# ams-key key@789
Command Information
AP Platform
Command Mode
All platforms
Configuration mode
4.1.22 ap1x
Description
This command sets the 802.1X authentication type on the uplink ports of AP.
Syntax
ap1x {peap|tls {tpm|user}} [validate-server]
no…
Parameter
Description
peap
Configures PEAP based 802.1X authentication type.
tls
Configures TLS based 802.1X authentication type.
tpm
Configures a factory- installed TPM certificate for AP authentication.
validate-server
Validates the authentication server credentials against the CA certifi-
cate in the AP database.
no…
Removes the configuration.