Siemens SCALANCE W1750D CLI - Show Ap Debug Airwave-Config-Received

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
311
Last connect trigger
:retry auth
Last connect fail status
------------------------
Last fail server Last fail time
Last fail reason
Last login done status
----------------------
Last connect done
:2018-01-25 07:12:37
The output of this command includes the following information:
Column
Description
Domain/IP Address
Displays the IP address or domain name of the AirWave server.
Type
Displays the type of the AirWave server. For example, backup or primary
server.
Mode
Indicates the mode of AirWave operation.
NOTE:
AirWave can be configured to operate in the Manage Read/Write or
Monitor-only+ Firmware Upgrades modes.
Config-only
Indicates whether AirWave is in the configuration mode. If yes, the AP
simplifies the report for AirWave.
Rapids-mode
Indicates whether AirWave is in RAPIDS mode. RAPIDS is a powerful tool
used for monitoring and managing security on wireless networks. The AP
can perform different actions when RAPIDS mode is enabled.
Status
Indicates the AirWave login status.
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.35 show ap debug airwave-config-received
Description
This command indicates if any configuration information is received by the AP from the
AirWave server.
Syntax
show ap debug airwave-config-received