Siemens SCALANCE W1750D CLI - Show Interface Counters

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
511
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.142 show interface counters
Description
This command shows the Ethernet interface packet counters for the AP.
Syntax
show interface counters
Usage Guidelines
Use this command to view table of L2 interface counters.
Example
The following example shows the partial output of show interface counters command:
bond0 is up, line protocol is up
Hardware is Gigabit Ethernet, address is d8:c7:c8:c4:42:98
Speed 1000Mb/s, duplex full
Received packets 9441
Received bytes 1134064
Receive dropped 0
Receive errors 0
Receive missed errors 0
Receive overrun errors 0
Receive frame errors 0
Receive CRC errors 0
Receive length errors 0 T
ransmitted packets 16435
Transmitted bytes 841278
Transmitted dropped 0
Transmission errors 0