Siemens SCALANCE W1750D CLI - Hotspot-Anqp-Ip-Addr-Avail-Profile

CLI Commands
4.8 H
SCALANCE W1750D CLI
124 Function Manual, 03/2019, C79000-G8976-C452-04
Usage Guidelines
Use this command to configure a domain name in the ANQP Domain Name profile. If a client
uses the GAS to post an ANQP query to an AP, the AP will return an ANQP Information
Element with the domain name when this profile is associated with a hotspot profile and
enabled on a WLAN SSID profile.
Example
The following command defines a domain name for the ANQP domain name profile:
(scalance)(config)# hotspot anqp-domain-name-profile domain1
(scalance)(domain-name "domain1")# domain-name example.com
(scalance)(domain-name "domain1")# enable
(scalance)(domain-name "domain1")# end
(scalance)# commit apply
Command Information
AP Platform
Command Mode
All platforms Configuration mode and the ANQP domain profile
configuration sub-mode
4.8.7 hotspot-anqp-ip-addr-avail-profile
Description
This command defines the available IP address types to be sent in an ANQP information
element in a GAS query response.
Syntax
hotspot anqp-ip-addr-avail-profile <profile-name>
enable
ipv4-addr-avail
ipv6-addr-avail
no…
Parameter
Description
hotspot anqp-ip-addr-
avail-profile
<profile-name>
Creates an ANQP IP Address availability profile.
enable
Enables the IP address availability profile.