Siemens SCALANCE W1750D CLI - Show Usb Status

CLI Commands
4.16 S
SCALANCE W1750D CLI
596 Function Manual, 03/2019, C79000-G8976-C452-04
------ ---------- ------------------- ------------
The output of this command displays information about the voice calls, the SSIDs on which
TSPEC is enabled, and the AP clients connected to the SSIDs with TSPEC enabled.
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.216 show usb status
Description
This command displays the status of the cellular modem link on the AP.
Syntax
show usb status
Usage Guidelines
The USB devices connected to anAP can be enabled or disabled according to uplink
configuration settings. The
show usb status command displays the status of the USB
connected to the AP.
Example
The following example shows the output of the show usb status command:
(scalance)(config)# show usb status
Cellular Status
---------------
card
detect
link
SIM PIN
----
------
----
-------
Present
detect-ok
Linkup
N/A
USB Modem Information
---------------------
Parameter
Value
---------
------
Manufacturer
Linux
Product
OHCI Host Controller
Serial Number
0000:00:04.0