Siemens SCALANCE W1750D CLI - Show Ipv6 Interface

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
519
192.168.10.0
0.0.0.0
255.255.254.0
U
0
0
0
br0
0.0.0.0
10.17.88.129
0.0.0.0
UG
0
0
0
br0
The output of this command provides the following information:
Column
Description
Destination
Displays the destination IP address for the IP routes.
Gateway
Displays the gateway IP address for the IP routes.
Genmask
Displays the subnet mask details for the IP routes.
Flags
Indicates if the route is up (U), targeted to the host (UH), or if it uses Gate-
way (UG).
MSS
Indicates the default MSS for TCP connections over this route.
Window
Indicates the default window size for TCP connections over this route.
irrt
Indicates the initial RTT. The kernel uses this to determine the best TCP
protocol parameters instead of relying on slow responses.
Iface
Indicates the Interface to which packets are routed.
Command Information
AP Platform
Command Mode
All platforms Privileged EXEC mode
4.16.149 show ipv6 interface
Description
Shows IPv6-related information for all interfaces on the AP.
Syntax
show ipv6 interface {brief|details}
Parameter
Description
brief
Displays a brief summary of the IPv6-related information on all
interfaces of an AP.
details
Displays detailed information on the interfaces that support IPv6.
Usage Guidelines
Use this command to view IPv6 related information on an AP.
Example
The following example shows the output of the show ipv6 interface brief command: