Siemens SCALANCE W1750D CLI - Ip Radius

CLI Commands
4.9 I
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
189
Command Information
AP Platform
Command Mode
All platforms Configuration mode and IPM configuration sub-
mode.
4.9.14 ip radius
Description
This command configures global parameters for configured RADIUS servers.
Syntax
ip radius rfc-3576-server udp-port <port>
Parameter
Description
Range
Default
rfc-3576-server
Configures the UDP port to receive
requests from a RADIUS server.
NOTE:
This parameter can only be
used on Virtual Controller.
— —
udp-port
Indicates the UDP port to receive
server requests.
— —
<port>
Indicates the port number.
1–65535
3799
Usage Guidelines
This command configures global RADIUS server parameters. The rfc3576 parameter must
be enabled in the
wlan auth-server command for the global RADIUS server configuration to
take effect.
Example
The following example configures the UDP port:
(scalance)(config)# ip radius rfc-3576-server udp-port 1700
(scalance)(config)# end
(AP )# commit apply
Command Information
AP Platform
Command Mode
All platforms
Configuration mode