Siemens SCALANCE W1750D CLI - Hotspot H2 Qp-Oper-Class-Profile

CLI Commands
4.8 H
SCALANCE W1750D CLI
138 Function Manual, 03/2019, C79000-G8976-C452-04
Parameter
Description
tcp-http
Enables the HTTP port. (port 80)
tcp-pptp-vpn
Enables the PPTP port used by IPSec VPNs. (port 1723)
tcp-ssh
Enables the SSH port. (port 22)
tcp-tls-vpn
Enables the TCP TLS port used by VPNs. (port 80)
tcp-voip
Enables the TCP VoIP port. (port 5060)
udp-ike2
Enables the IKEv2 port.
udp-ipsec-vpn
Enables the IPsec VPN port. (ports 500, 4500 and 0)
udp-voip
Enables the UDP VoIP port. (port 5060)
no…
Removes any existing configuration.
Usage Guidelines
Use this command to configure the values to be sent in an ANQP IE to provide information
about the IP protocols and associated port numbers that are available and open for
communication.
Example
The following example allows the H2QP connection capability profile to advertise the
availability of ICMP and HTTP ports.
(scalance)(config) # hotspot h2qp-conn-cap-profile Wan1
(scalance)(connection-capabilities "Wan1")# icmp
(scalance)(connection-capabilities "Wan1")# tcp-http
(scalance)(connection-capabilities "Wan1")# enable
(scalance)(connection-capabilities "Wan1")# end
(scalance)# commit apply
Command Information
AP Platform
Command Mode
All platforms Configuration mode and the H2QP connection
capability profile configuration sub-mode
4.8.13 hotspot h2qp-oper-class-profile
Description
This command configures a H2QP profile that defines the Operating Class to be sent in the
H2QP IE.