Siemens SCALANCE W1750D CLI - Hotspot Anqp-Roam-Cons-Profile

CLI Commands
4.8 H
SCALANCE W1750D CLI
132 Function Manual, 03/2019, C79000-G8976-C452-04
4.8.10 hotspot anqp-roam-cons-profile
Description
This command configures the Roaming Consortium OI information to be sent in an ANQP
information element in a GAS query response.
Syntax
hotspot anqp-roam-cons-profile <profile-name>
enable
roam-cons-oi <roam-cons-oi>
roam-cons-oi-len <roam-cons-oi-len>
no…
Parameter
Description
Range
hotspot anqp-roam-cons-
profile
<profile-name>
Creates roaming consortium profile. —
enable
Enables the roaming consortium profile.
—
roam-cons-oi
<roam-cons-oi>
Sends the specified roaming consortium OI in a GAS
query response. The OI must be a hexadecimal num-
ber 3-5 octets in length.
Hexadecimal
number 3-5
octets in
length
roam-cons-oi-len
<roam-cons-oi-len>
Indicates the length of the OI. The value of the
roam-
cons-oi-len
parameter must equal upon the number of
octets of the
roam-cons-oi
field.
•
0
: 0 Octets in the OI (Null)
•
3
: OI length is 24-bit (3 Octets)
•
5
: OI length is 36-bit (5 Octets)
—
no…
Removes any existing configuration.
—
Usage Guidelines
Use this command to configure the roaming consortium OIs assigned to service providers
when they register with the IEEE registration authority. The Roaming Consortium Information
Elements contain information about the network and service provider, whose security
credentials can be used to authenticate with the AP transmitting this IE.
Example
The following command defines the roaming consortium OI and OI length in the ANQP
roaming consortium profile:
(scalance)(config)# hotspot anqp-roam-cons-profile profile1
(scalance)(roaming-consortium "profile1")# roam-cons-oi 506F9A