Siemens SCALANCE W1750D CLI - Show Radius Status

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
565
The output of this command provides the following information:
Parameter
Description
Name
Indicates the name of the RADIUS server.
IP address
Indicates the IP address of the RADIUS server.
Port
Indicates the authorization port number of the RADIUS server.
AcctPort
Indicates the authorization port number of the RADIUS server.
Key
Indicates the key for communicating with the RADIUS server.
Timeout
Indicates timeout value in seconds for one RADIUS request.
Retry count
Indicates the maximum number of authentication requests sent to the
RADIUS server.
NAS IP address
Displays the IP address of the NAS if NAS is configured.
NAS Identifier
Indicates the NAS identifier to be sent with the RADIUS requests.
In Use
Indicates if the server is in use.
RFC3576
Indicates if the APs are configured to process RFC 3576-compliant Change
of Authorization (CoA).
Airgroup RFC3576-
ONLY
Indicates if APs are configured to be RFC 3576 compliant only.
Airgroup RFC3576
port
Indicates the port number used for sending AirGroup CoA.
Deadtime
Indicates the RADIUS server dead-time.
DRP IP
DRP Mask
DRP VLAN
Indicates the IP address, net mask, and DRP VLAN configured for Dynamic
Proxy Radius (DRP).
RadSec RadSec Port
Indicates if RadSec protocol for the RADIUS communiation over TLS is
enabled. If RadSec is enabled, the RadSec port number is displayed.
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.195 show radius status
Description
This command displays the status of TLS tunnel between the AP and RadSec proxy.
Syntax
show radius status