Siemens SCALANCE W1750D CLI - Page 566

CLI Commands
4.16 S
SCALANCE W1750D CLI
566 Function Manual, 03/2019, C79000-G8976-C452-04
Usage Guidelines
Use this command to view the status of TLS tunnel when RADIUS communication over TLS
is enabled on an AP.
Example
The following example shows the output of show radius status command:
Radius server status
--------------------
Name
Server IP Source IP Server Name Protocol
Port
Connected sock-
ets
---- --------- --------- ----------- --------
InternalServer 127.0.0.1
10.17.129.253 Not configured
RADIUS/UDP
----
1616
----------------
-
Not Applicable
test 10.0.0.1 10.17.129.253 Not configured
RADIUS/UDP
1812
Not Applicable
t_test 127.0.0.1 10.17.129.253 Not configured
RADIUS/UDP
2630
Not Applicable
Radius1 10.0.0.2 10.17.129.253 Not configured
RADIUS/UDP
1812
Not Applicable
t_Radius1 127.0.0.1 10.17.129.253 Not configured
RADIUS/UDP
2632
Not Applicable
Status
Last connection tried at
Next connection at
------
------------------------
------------------
Not Applicable
Not Applicable
Not Applicable
Not
Applicable
2015-07-07
00:00:00.00000
0
2015-07-07
00:00:05.5000000
Not
Applicable
2015-07-07
00:00:00.00000
0
2015-07-07
00:00:05.5000000
Not
Applicable
2015-07-07
00:00:00.00000
0
2015-07-07
00:00:05.5000000
Not
Applicable
2015-07-07
00:00:00.00000
0
2015-07-07
00:00:05.5000000
The output of this command provides the following information:
Parameter
Description
Name
Indicates the name of the RADIUS server.
Server IP
Indicates the IP address of the RADIUS server.
Source IP
Indicates the source IP address.
Server Name
Indicates the name of the server.
Protocol
Indicates the type of protocol used for RADIUS communication with the
AP clients.
Port
Indicates the authorization port number of the RADIUS server.
Connected Sockets
Indicates connected sockets if any.
Status
Indicates status of the server connection.
Last connection tried
at
Indicates the time stamp during which the last connection between the
server and client was attempt.
Next connection at
Indicates the time at which the next attempt will be made to establish
the connection with the RADIUS server.