Siemens SCALANCE W1750D CLI - Enet0-Bridging; Enet0-Port-Profile

CLI Commands
4.5 E
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
103
4.5.2 enet0-bridging
Description
This command allows you to use all ports on the APs as downlink ports.
Syntax
enet0-bridging
Usage Guidelines
Use this command for AP models that have only one Ethernet port enabled. When Ethernet
0 bridging is configured, ensure that the uplink for each AP is mesh link, Wi-Fi, or 3G or 4G.
Example
The following command enables Eth0 bridging:
(scalance)# enet0-bridging
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.5.3 enet0-port-profile
Description
This command assigns a wired profile to the ENET 0 port on an AP.
Syntax
enet0-port-profile <profile>
Parameter
Description
enet0-port-profile <pro-
file>
Assigns a wired profile to the Ethernet 0 interface port.
Usage Guidelines
Use this command to assign a wired profile to the Ethernet 0 port to activate the wired
profile.