Siemens SCALANCE W1750D CLI - Hotspot H2 Qp-Wan-Metrics-Profile

CLI Commands
4.8 H
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
145
Command Information
AP Platform
Command Mode
All platforms Configuration mode and the H2QP OSU provider
profile configuration sub-mode.
4.8.16 hotspot h2qp-wan-metrics-profile
Description
This command configures a H2QP profile that specifies the hotspot WAN status and link
metrics.
Syntax
hotspot h2qp-wan-metrics-profile <profile-name>
at-capacity
downlink-load <load>
downlink-speed <speed>
enable
load-duration <duration> symm-
symm-link
uplink-load <load>
uplink-speed <speed>
wan-metrics-link-status <status>
no…
Parameter
Description
Range
Default
hotspot h2qp-wan-
metrics-profile
<profile-name>
Creates a H2QP WAN metric profile — —
at-capacity
Indicates if the WAN Link has reached
its maximum capacity. If this
parameter is enabled, no additional
mobile devices will be permitted to
associate to the hotspot AP.
— —
downlink-load
<load>
Configures the percentage of the WAN
downlink that is currently utilized. If no
value is set, this parameter will show a
default value of 0 to indicate that the
downlink speed is unknown or unspec-
ified.
1-100 0
(unspecified)