Siemens SCALANCE W1750D CLI - Allow-New-Aps; A-Max-Clients

CLI Commands
4.1 A
SCALANCE W1750D CLI
42 Function Manual, 03/2019, C79000-G8976-C452-04
4.1.16 allow-new-aps
Description
This command allows the new access points to join the AP cluster.
Syntax
allow-new-aps
no…
Parameter
Description
allow-new-aps
Allows new access points in the domain.
no
Removes the specified configuration parameter.
Usage Guidelines
Use this command to allow the new access points to join the AP cluster. When this
command is enabled, only the licensed slave APs can join the cluster.
Example
The following command allows the new APs to join the cluster.
(scalance)(config)# allow-new-aps
Command Information
AP Platform
Command Mode
All platforms
Configuration mode
4.1.17 a-max-clients
Description
This command configures the maximum number of clients allowed for an SSID profile on a 5
GHz radio channel.