Siemens SCALANCE W1750D CLI - Pppoe-Uplink-Profile

CLI Commands
4.14 P
SCALANCE W1750D CLI
218 Function Manual, 03/2019, C79000-G8976-C452-04
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.14.8 pppoe-uplink-profile
Description
Use this command to configure PPPoE uplink profile.
Syntax
pppoe-uplink-profile <profile>
pppoe-username <username>
pppoe-passwd <password>
pppoe-svcname <svcname>
pppoe-chapsecret <password>
pppoe-unnumbered-local-l3-dhcp-profile <dhcp-profile>
no…
Parameter
Description
pppoe-uplink-profile <pro-
file>
Creates an uplink profile and enables the PPPoE uplink profile
configuration mode.
pppoe-username <username>
Configures a user name to allow a user to log into the DSL net-
work.
pppoe-passwd <password>
Configures a password for the user to log into the DSL network.
pppoe-svcname <svcname>
Specifies the PPPoE service provided by your service provider.
pppoe-chapsecret <password>
Configures a secret key used for Challenge Handshake Authenti-
cation Protocol (CHAP) authentication.
You can use a maximum of 34 characters for the CHAP secret
key.
pppoe-unnumbered-local-l3-
dhcp-profile <dhcp-profile>
Configures the Local, L3 DHCP gateway IP address as the local
IP address of the PPPoE interface. When configured, the local
interface acts as an unnumbered PPPoE interface and allows the
entire Local, L3 DHCP subnet to be allocated to clients.
no…
Removes the configuration.
Usage Guidelines
Use this command to configure PPPoE uplink connection for an AP.