Siemens SCALANCE W1750D CLI - Out-Of-Service-Hold-On-Time

CLI Commands
4.13 O
SCALANCE W1750D CLI
212 Function Manual, 03/2019, C79000-G8976-C452-04
Command Information
AP Platform
Command Mode
All platforms
Configuration mode
4.13.4 out-of-service-hold-on-time
Description
This command configures a hold on time in seconds, after which out-of-service operation is
triggered. For example, if the VPN is down, the effect of this out-of-service state impacts the
SSID availability after the configured hold on time
Syntax
out-of-service-hold-on-time <time>
no…
Command/Parameter
Description
Range
Default
<time>
Configures the hold on time of out-of-
service operations.
30–300 sec-
onds
30 seconds
no…
Removes the configuration
—
—
Usage Guidelines
Use this command to configure a hold time after which the out-of-service operation is
triggered.
Example
The following example sets the out of service hold on interval to 45 seconds:
(scalance)(config)# out-of-service-hold-on-time 45
Command Information
AP Platform
Command Mode
All platforms
Configuration mode