Siemens SCALANCE W1750D CLI - Show Tacas-Servers

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
591
Parameter
Description
wireless
Generates a log about radio configuration.
syslog-
level<level>
Displays any of the following Syslog logging level configured for the Syslog facility.
• Emergency—Panic conditions that occur when the system becomes unusable.
• Alert—Any condition requiring immediate attention and correction.
• Critical—Any critical conditions, for example, hard drive error.
• Errors—Error conditions.
• Warning—Warning messages.
• Notice—Significant events of a non-critical and normal nature. The default
value for all Syslog facilities.
• Informational—Messages of general interest to system users.
• Debug—Messages containing information useful for debugging.
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.211 show tacas-servers
Description
This command displays all the tacacs servers configured on an AP.
Syntax
show tacacs-servers
Usage Guidelines
Use this command to view the list of tacacs servers available on an AP.
Example
The following example shows the output of the show tacacs-servers command:
TACACS Servers
--------------
Name IP Address Port Key Timeout Retry Count In Use
---- ---------- ---- --- ------- ----- ----- ------
tacacs1 10.64.16.240 49 pass123 20 1 Yes